Newton 120In extras go to connection -> click on i -> select Modem Prefs set set to Hayes 28.8 (or if this fails to Hayes basic). Activate "tone dialing" en disactivate "recognition of dialtone".Newton 130Please try to change one of the other HAYES settings included in the modem setup dialog. For the Newton 130 the speed of the setting is irrelevant to the connection. Make sure he has checked the "ignore dialtone option". The "no modem detected" error is an internal modem error message that could be caused by many reasons, e.g. the telephone numer and line.Newton 2000Download shareware version of the modemmodifier (www.novamedia.de) and install on Newton. There is a setting EC (Error Correction), disable this (click on hook). Next load 28.8 or faster driver (included in 2000). Also try setting command Timeout from 2000 to 3000, and the Intercommand delay from 25 to 35. If all else fails try the Applefax driver and change speed to 28.8.If this fails please try all the drivers in the Newton Modem setup - if the card stil does not work: have you closed the hatch at the rear of the Newton, so that the message "A communications card has been inserted" appears?If so, the ROM Version of your Nokia Handy has to be the latest one. To check that, you will have to go to your Nokia Dealer and have it updated. The Update should cost the equivalent of 70 German Mark - so do not pay any fantasy prices for the upgrade!Also check the following site where you can download the modemmodifier.http://www.novamedia.de/001it11e.htmModem Modifier is a shareware program for all Newtons with OS 2.0 and higher. It allows you to patch the pre-installed modem drivers ("Config." "Modem") and save them seperately. MP2K-Users arerecommended to install Modem Modifier until there's a new generation of OPTION cards. Right now the setting "EC" e.g."Error Correction" in GSM mode with OPTION GSM-ReadyŽ Cards should be DEACTIVATED to be capable forFAX RECEIVING in cellular mode on MP2K devices. Procedure: Downloading Modem Modifier, unpacking it and installing on the Newton Choosing the driver "28.8 andfaster" with button "COPY", scrolling down till EC as an option accurs. Deactivating EC (false). Also helpful is thefollowing: setting InterCommandDelay from 25 to 35 and CommandsTimeOut from 2000 to 3000. Try adding S95=0 at the end of all the init string (not in Modem ID). Save this patcheddriver as "OPTION" - that's it!